Recommended Order Of Creation - Siemens SINAMICS S120 Commissioning Manual

With startdrive
Hide thumbs Also See for SINAMICS S120:
Table of Contents

Advertisement

Commissioning
4.4 Creating a project offline in Startdrive
This information is generated and administered in the user administration of the TIA Portal.
Detailed information on project protection can be found in the Startdrive online help under
"Using user administration".
4.4.2

Recommended order of creation

After a new project has been created, the required components must be inserted into the
device configuration – and in most cases, also specified. If an optimum sequence is
maintained when inserting the components, then the inserted components are also
automatically wired.
Recommended order:
1. Control Unit
2. Infeed unit
3. Motor Module (or Power Module)
4. Motor
5. Encoder (measuring system)
6. Supplementary system components (Terminal Module, Terminal Board, Communication
Board, Voltage Sensing Module)
If this sequence is not complied with (e.g. because the infeed unit is only subsequently
added), then it is possible that Startdrive does not automatically wire the components. In this
case, you must manually establish the wiring in the device view (see Chapter "Editing a
DRIVE-CLiQ connection (Page 100)").
Note
For some motors, a corresponding sensor is created in the device view upon
creation/specification of a motor. The corresponding encoder is specified together with the
motor.
Note
When you use Power Modules, it is usually possible to dispense with an infeed. Point 2 in
the list above is then no longer applicable.
86
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1

Advertisement

Table of Contents
loading

Table of Contents