Displaying The Trace Recording - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
5.3 Diagnostics via Startdrive
Activating the trace recording
Proceed as follows to activate the trace recording in the drive:
1. Click on icon
The trace is activated in the drive and starts the recording corresponding to the
configured trigger condition.
The current status of the recording is displayed in the status display of the trace.
Note
When a recording is restarted, the previously recorded values are lost.
To save the values that have been recorded, save the measurement in the project (see
Chapter "Saving measurements in the project (Page 347)"), before you reactivate the
recording.
Deactivating the trace recording
Proceed as follows to exit the activated trace recording in the drive:
1. Click on icon
The trace is deactivated in the drive.
The status display of the trace changes to "Inactive".
5.3.2.6

Displaying the trace recording

Requirement
● An online connection has been established to the drive.
● A recorded trace is saved in the drive.
Or:
● A measurement is in the "Measurements" system folder.
Procedure
To display the recording, proceed as follows:
1. Select a trace in the drive.
2. Double-click the selected trace.
3. If required, activate the icon
4. Check to ensure that the signals (
You can display the signals via the shortcut menu.
346
.
.
for monitoring.
) are shown in the "Diagram" tab in the signal table.
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1