Siemens SINAMICS S120 Commissioning Manual page 158

Commissioning
4.6 Alternatively: Creating a project with a device configuration derived from the hardware
Deleting a component
1. Select the components which are to be deleted.
2. Call the "Delete" shortcut menu.
The component is deleted.
Note
All components in the "Non-assignable components" folder prevent the creation of this read-
out actual topology of the drive unit in the device configuration.
If individual components which have not yet been assigned cannot be assigned to a main
component, delete the corresponding list entries in the "Non-assignable components" folder,
in order that the remaining components can be adopted in the device configuration.
Renaming the component
1. Select the components which are to be renamed.
2. Call the "Rename" shortcut menu.
3. Enter a new name for the component.
Connecting components in parallel
The parallel connection view supports you in the parallel connection of components.
1. Activate the "Parallel connection view" option.
The "Connect in parallel at" shortcut menu is now available (see Step 2).
2. The following options are available for connecting components in parallel:
– Drag and drop
– Shortcut menu:
Cancelling a parallel connection
You can cancel an existing parallel connection as follows:
1. Drag components to the higher-level drive unit using drag and drop.
- Or -
2. Select a component connected in parallel and select the "Disconnect parallel connection"
shortcut menu.
158
Drag the components that can be connected in parallel using drag and drop to
connect them in parallel.
Right-click the components to be connected in parallel. In the shortcut menu, the
"Connect in parallel" menu item shows all the drive objects to which the selected
component can be connected in parallel.
The "All" item switches the selected power unit parallel to all connectable components.
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1