Lift Arm Down Pressure Adjustment
The down pressure spring on each cutting unit lift arm
can be adjusted to compensate for different turf condi
tions. Increased down pressure will help keep the cut
ting units on the ground when mowing at higher speeds
and helps maintain a uniform height of cut in rough
conditions or in areas of thatch build up.
Each down pressure spring may be adjusted to one of
four (4) settings. Each increment increases or de
creases down pressure on cutting unit by 8 lbs.
1. Put machine on a level surface, lower the cutting
units, stop the engine, engage the parking brakes and
remove key from ignition switch.
2. Remove floor plate in front of seat and open the hood
to get access to all five (5) springs.
CAUTION
Springs are under tension. Use caution when
ad usting.
j
3. Put an open end wrench on hex shaft of spring
bracket.
NOTE: Because wrench can be moved only a limited
distance, it may be necessary to use a second wrench
to hold hex shaft while re-positioning other wrench for
further rotation of hex shaft.
4. Remove capscrew and locknut securing retaining
bracket, while rotating hex shaft to relieve spring ten
sion.
5. Move spring bracket to desired position and install
capscrew and locknut, while rotating hex shaft to relieve
spring tension.
Set Up and Adjustments
Page 8 - 14
2
1
Figure 16
1. Spring bracket hex shaft
2. Retaining bracket
®
Reelmaster
223-D/5100-D/5300-D