Electronic Control Unit (ECU) Replacement
IMPORTANT: Before welding on the machine, dis
connect both battery cables from the battery, dis
connect both wire harness connectors from the
ECU and disconnect the terminal connector from
the alternator to prevent damage to the electrical
system.
1. Stop the engine.
2. Remove nuts securing ECU to frame.
3. Loosen nuts on wiring connectors with a 1/4" nut
driver, then disconnect wiring connectors from ECU
(Fig. 40).
4. Remove ECU.
5. To install ECU, connect wiring connectors to ECU,
then tighten nuts on wiring connectors. Secure ECU to
frame with nuts removed in step 2.
®
Reelmaster
5100-D
Page 5 - 35
1
2
Figure 40
1. Electronic control unit (ECU)
2. Wiring connectors
Repairs