Repairs
Cutting Unit Removal and Installation
Remove cutting unit from traction unit before doing
adjustments or repairs.
1. Remove basket from cutting unit.
2. Disconnect chain from cross tube on each rear cutting
unit (Fig. 17).
3. Loosen reel motor mounting nuts (Fig. 18). Rotate the
motor clockwise so motor flanges clear studs and pull
motor off of cutting unit.
4. Remove capscrew, lock washer, flat washer and
thrust washer from cutting unit mounting shaft (Fig. 19).
5. Pull cutting unit off mounting shaft.
6. Reverse steps 1 - 5 to install cutting unit.
®
Reelmaster
223-D/5100-D/5300-D
1
1
1. Reel drive motor
3
1. Cutting unit mounting shaft
2. Carrier tube frame pivot tube
3. Capscrew, lockwasher, flat washer and thrust washer
Page 8 - 15
Figure 17
1. Lock up chain
Figure 18
2. Mounting nuts
2
Figure 19
2
1
Repairs