Toro Reelmaster 5100-D Service Manual page 170

Condition
__ ________________________________________________________________________________________
Engine kills when traction pedal
is depressed.
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
Battery does not charge.
Cutting Unit Operation Problems
Condition
__ ________________________________________________________________________________________
Cutting units remain engaged,
but should not, with no operator
on seat.
_____________________________________________ ________________ ______ ________________ ______ ________________ ___________________________________
Cutting units run, but should not,
when raised (but shut off with
Enable/Disable switch).
Troubleshooting
Possible Cause
Seat lifting off seat switch.
Seat switch circuit open.
__ __ __
Alternator belt slipping.
Faulty wiring.
Malfunctioning alternator.
Faulty battery.
Possible Cause
Seat switch circuit closed.
__ __ __
Front reels down sensor closed.
Page 5 - 12
Correction
Instruct operator to sit back in
seat during operation.
Check seat plate hinges and seat
support pin and repair if faulty.
Test seat switch and replace if
faulty.
Check seat switch wiring and
repair if faulty.
__ __ __
Adjust belt tension.
Check and repair wiring.
Repair or replace alternator.
Replace battery.
Correction
Check seat plate hinges and seat
support pin and repair if faulty.
Check for water soaked seat
cushion.
Check seat switch and replace if
faulty.
Check seat switch circuit wiring
and repair if faulty.
__ __ __
Test front reels down sensor and
replace if faulty.
Check front reels down sensor
wiring and repair if faulty.
®
Reelmaster 5100-D