Toro Reelmaster 5100-D Service Manual page 311

If bracket (Item 3) was not removed:
Slide bearing assembly onto traction shaft. Loosely
mount bearing support (Item 5) to bracket (Item 3)
with three (3) carriage bolts (Item 1) and locknuts
(Item 6).
4. Slide locking collar (Item 25) onto traction shaft
(Item 31). Do not tighten at this time.
Installing Drive Shaft.
1. Apply never-seize to splines of traction shaft and axle
input shaft.
2. Slide clutch end of drive shaft onto rear axle shaft
spline, aligning roll pin hole in shaft with hole in axle
coupling (Item 15). Install roll pin (Item 18) through
coupling and shaft.
3. Tighten two (2) capscrews (Item 19) and locknuts
(Item 6) to secure coupling to shaft.
4. Slide yoke end (Item 7) of drive shaft onto traction
shaft spline (Item 31).
®
Reelmaster 223-D/5100-D/5300-D
5. Tighten two (2) capscrews (Item 19) and locknuts
(Item 6) to secure yoke to shaft.
Do steps 6 - 9 only if traction shaft (Item 31) was
removed:
6. Block front tires and jack up rear wheels of machine
until there is approximately one inch clearance between
rear tires and the ground. SECURELY BLOCK FRAME.
7. Using an open end torque wrench on square slip yoke
shaft (Item 9) of drive shaft assembly, tighten traction
shaft (counterclockwise) to a torque of 110 - 120 ft-lb.
8. Tighten locknuts (Item 6) securing bearing to bracket.
9. Rotate locking collar (Item 25) in a clockwise direc­
tion, as viewed from rear of machine. Tighten collar onto
shaft by carefully rotating it with a hammer and punch.
tighten set screw.
Page 9 - 7 Repairs