Driveshaft Seals; Gearcase Assembly; Propeller Shaft, Gear And Shifter Installation - BRP Evinrude E-TEC Series Service Manual

Driveshaft Seals

Apply Gasket Sealing Compound to the metal
casing of the seals before installing.
Use Seal Installer, P/N 326552, to install the inner
seal with flush lip facing into the gearcase, then
the outer seal with extended lip facing out of the
gearcase.
Apply Triple-Guard grease to the seal lips after
installing.
2
3
1. Seal Installer, P/N 326552
2. Inner seal
3. Outer seal

GEARCASE ASSEMBLY

Propeller Shaft, Gear and Shifter
Installation
IMPORTANT:
cate all bearings, shafts, and gears with gearcase
lubricant.
Oil and place the forward bearing cone and roller
assembly in the forward bearing cup.
1
Install the small thrust washer with the chamfered
inside diameter facing the pinion gear. Oil and
install the thrust bearing. Install the large thrust
washer with chamfered outside edge facing up.
DR2061
DR2062
3
1
1. Small thrust washer, chamfered inside diameter
2. Thrust bearing
3. Large thrust washer, chamfered outside edge
GEARCASE
GEARCASE ASSEMBLY
Make no dry assemblies. Lubri-
38635
2
803051
12
261