BRP Evinrude E-TEC Series Service Manual page 182

POWERHEAD
POWERHEAD ASSEMBLY
If the installer sticks on the sleeve after installa-
tion, thread Slide Hammer, P/N 391008, into
installer and pull it off.
IMPORTANT:
Inspect sleeve after installation.
Sleeve must not be used if surface is damaged.
Use retaining ring pliers to install bearing retaining
ring with sharp edge facing away from bearing.
Lubricate a new driveshaft O-ring and lightly lubri-
cate crankshaft splines with Moly Lube. Install
O-ring in sleeve.
2
1. Bearing retaining ring
2. O-ring
Lightly coat the outside edge of a new lower hous-
ing seal with Gasket Sealing Compound. Press
against outer case of the seal to install seal in the
lower housing with extended lip facing down.
Lubricate seal lip with Moly Lube.
1. Seal lip
180
Install a new O-ring on the lower housing. Before
installing crankshaft into cylinder block, apply a
thin coat of Gasket Sealing Compound to outer
edge of O-ring.
Place lower seal housing on crankshaft.
1
1
1. Lower seal housing
2. O-ring
Lubricate upper main bearing with outboard lubri-
cant and install on crankshaft.
007797
1. Upper main bearing
Pack lip of upper oil seal with Moly Lube. Place
seal on crankshaft with lip toward driveshaft and
1
007798
2
007799
1
007760