Propeller Shaft Bearing Housing Installation - BRP Evinrude E-TEC Series Service Manual

GEARCASE
GEARCASE ASSEMBLY
Holding the shifter yoke a with long-nose pliers,
install the yoke at a tilted position, locating top of
yoke into upper gearcase cavity.
1
1. Shifter yoke
2. Top of yoke
Engage the shifter yoke hook onto the shifting
lever clevis pin in bottom of the gearcase cavity.
1. Shifter yoke hook
Apply Triple-Guard grease to threads of lower shift
rod and install into gearcase through the water
intake opening and engage the shifter yoke.
264
Thread the shift rod into the shifter yoke until the
rod bottoms in the yoke.
2
1. Lower shift rod
COA3229
Propeller Shaft Bearing
Housing Installation
Slide the retainer plate down the propeller shaft
and into the gearcase with tab facing down.
1
COA3230
1. Tab, retainer plate
WARNING
Wear safety glasses and proceed with
care to avoid unsnapping the ring from the
pliers.
Using Retaining Ring Pliers, P/N 331045, install
the retaining ring into groove in gearcase with
sharp outside edge facing aft.
1
007672
1
COA3238