Recoil Starter Disassembly; Safety - BRP Evinrude E-TEC Series Service Manual

Position the charge module harness, connectors
and wiring as shown.
Assemble and tighten tie straps through the tie
strap slots of the recoil housing.
Attach fuse holder to retainer.
Attach remaining connectors to retainers on recoil
housing as shown.
1
1. Battery charge module harness
2. Tie straps
3. Fuse holder
Position the EMM on the starter housing. Install
and tighten self-taping screws carefully.
IMPORTANT:
Turn self-tapping screws counter
clock-wise to start the threads and clockwise to
tighten. Failure to follow this procedure can dam-
age the threads of the housing.
1
4. EMM
5. Self-tapping screws
Connect the cooling hose to the EMM. Secure
with tie strap.
2
3
007232
2
007241

RECOIL STARTER DISASSEMBLY

RECOIL STARTER
DISASSEMBLY
WARNING
Wear safety glasses while disassembling
and assembling manual starters because
of rewind spring tension.
Use Starter Spring
P/N 342682, to service the recoil starter assembly.
1
2
3
1. Base
2. Retainer
3. Left-hand threaded nut
4. Stop tool
5. Handle
Pull the starter rope out completely. Retain pulley
in position by placing the stop tool from Starter
Spring Winder and Installer, P/N 342682 through
the hole in the pulley.
1. Stop tool
MANUAL STARTER
Winder and Installer,
4
5
50068A
1
007708
283
14