BRP Evinrude E-TEC Series Service Manual page 224

MIDSECTION
STERN BRACKET – MANUAL TILT MODELS
Place the shallow water drive link and reverse
lock assembly into the swivel bracket as shown
Install one pin as shown and secure pin with clip.
1. Pin
Install remaining pin through reverse lock assem-
bly and into boss. Use an appropriate tool to hold
spring in alignment. Push pin through spring and
swivel bracket. Secure pin with clip.
1
2
3
1. Pin
2. Boss
3. Spring
IMPORTANT:
Make sure the rounded end of the
spring is installed as shown.
1. Spring rounded end
222
Use an appropriate tool to hook the straight end
over the pin as shown.
1
1
1. Spring straight end
007606
Install the tilt lock lever and port stop link in the
swivel bracket. Install the bellcrank, temporarily
leave the bell crank screw loose.
1. Bellcrank
2. Tilt lock lever
3. Stop link
007607
Be sure the tilt lock lever cam and port stop link
cam are installed as shown.
2
1
1. Port stop link cam
2. Tilt lock lever cam
007608
007609
2
1
3
007610
1
007611
007612