Stern Bracket Assembly (Manual Tilt) - BRP Evinrude E-TEC Series Service Manual

Stern Bracket Assembly (Manual
Tilt)
Install a new bushing through hole in tilt lock
assembly. Press bushing into swivel bracket until
fully seated. Make sure tilt lock assembly moves
freely.
IMPORTANT:
Prevent damage to the tilt lock
assembly stop pin. Be sure to properly support the
swivel bracket when pressing in bushings.
1
1. Stop pin
1
1. Tilt lock assembly
2. Correct support
STERN BRACKET – MANUAL TILT MODELS
Assemble reverse lock link and reverse lock lever
as shown. Install pin and secure with new cotter
pin.
3
1. Reverse lock link
2. Reverse lock lever
3. Pin
Place pin through the shallow water drive link as
shown. Secure with new cotter pin.
007629
2
1. Shallow water drive link
2. Pin
Align reverse lock link assembly with shallow
water drive link as shown.
007603
1. Reverse lock link assembly
2. Shallow water drive link
MIDSECTION
1
2
007604
1
2
007630
11
1
2
007605
221