BRP Evinrude E-TEC Series Service Manual page 236

MIDSECTION
TILLER HANDLE SERVICE
Use an appropriate tool to align screw hole
through the tiller handle, bracket and base. Install
steering handle screw. Tighten screw so tiller han-
dle pivots easily. Refer to Tiller Handle Friction
on p. 25.
1
1. Steering handle screw
Install bushing, washer and nut on port side of
tiller handle. Tighten nut to a torque of 25 to 28 ft.
lbs. (35 to 38 N·m).
1. Nut
2. Washer
3. Bushing
Install the throttle friction control.
1. Throttle friction control
234
Press the trim switch into the twist grip. Be sure
trim switch UP position aligns with the twist grip
indicator line as shown.
1
1. Trim switch UP position
2. Indicator line
007548
Install trim switch wiring through inner steering
handle.
IMPORTANT:
twisted through the throttle twist grip or inner tiller
handle / wire guide.
Insert wire guide into inner steering handle.
1
3
2
1
007547
1. Inner tiller handle
2. Wire guide
3. Trim switch wires
1
007546
Trim switch wiring must NOT be
2
007554
3
2
007555