Mount Service - BRP Evinrude E-TEC Series Service Manual

MIDSECTION
EXHAUST HOUSING SERVICE

Mount Service

Individual upper and lower motor mounts can be
serviced without removing the exhaust housing.
Remove the lower motor covers. Refer to Lower
Cover Removal on p. 45.
Removal
Remove mount screw and washer(s).
Remove two mount to exhaust housing screws.
Remove mount.
2
1. Mount screw
2. Mount to exhaust housing screws
Check condition of the mounts. Replace if deterio-
rated or damaged.
Installation
Apply Triple-Guard grease to threads of the two
mount to exhaust housing screws.
204
Install mount to exhaust housing with two mount
to exhaust housing screws. Install screws finger
tight at this time.
1
1. Mount to exhaust housing screws
Upper mount: Install rubber bumper.
007569
1. Rubber bumper
1
007570
1
007571