Timing Adjustments; Timing Pointer; Timing Verification; Tps Calibration - BRP Evinrude E-TEC Series Service Manual

ELECTRICAL AND IGNITION

TIMING ADJUSTMENTS

TIMING ADJUSTMENTS

Timing Pointer

The timing pointer on Evinrude E-TEC 15 – 30 HP
models is not adjustable.

Timing Verification

Use Evinrude Diagnostics software to synchronize
the mechanical timing of the outboard with the
electronic timing of the EMM.
Start the outboard.
Use the Settings/Ignition Timing screen of the
diagnostics software and follow the on-screen
instructions.
Ignition Timing Screen
Check ignition timing after any of the following
procedures:
•
Powerhead replacement
•
Crankshaft replacement
•
Flywheel removal or replacement
•
CPS replacement
•
EMM replacement
•
EMM software replacement (reprogramming)
IMPORTANT:
Make sure the timing pointer is
set and the outboard reaches operating tempera-
ture before making any timing adjustments.
106

TPS Calibration

Use Evinrude Diagnostics software to tell the
EMM what throttle position sensor voltage is when
the throttle plates begin to open.
Set TPS Calibration after replacing or adjusting
any throttle body or throttle linkage parts.
Remove the air silencer.
Do NOT start the outboard.
On the Settings/Adjustments screen of the diag-
nostics software, click the "Set TPS Calibration"
button.
1
1. TPS Calibration button
While holding the throttle plates closed, advance
the throttle linkage until it stops. The Measured
008143
TPS Calibration field on the screen will increase.
Click the Working button in the software to cali-
brate the TPS.
Install the air silencer.
008144