Bearing And Seal Removal; Driveshaft Seals; Driveshaft Bearing - BRP Evinrude E-TEC Series Service Manual

GEARCASE

BEARING AND SEAL REMOVAL

Use long-nose pliers to remove the clutch and
shifter lever assembly. Use no force. Tilting the
shifter lever slightly will allow you to remove it
from the gearcase.
1
2
1. Clutch
2. Shifter lever assembly
Remove the forward bearing, forward gear, pinion,
pinion thrust bearing, and two pinion thrust wash-
ers.
256
BEARING AND SEAL
REMOVAL
IMPORTANT:
while in place. If bearing is damaged, remove and
discard. If the bearing is removed for any reason,
it must be replaced.

Driveshaft Seals

Use Puller Bridge, P/N 432127, and Small Puller
Jaws, P/N 432131, to remove the two driveshaft
seals. Discard the seals.
007677

Driveshaft Bearing

Use Puller Bridge, P/N 432127, and Small Puller
Jaws, P/N 432131 to remove the driveshaft bear-
ing and sleeve from the gearcase. Discard the
bearing.
007678
Inspect bearings for damage
38633
38634