[Pr. Pf89_Drive Recorder - Analog Channel Setting 3 (Drac3)]; [Pr. Pf90_Drive Recorder - Analog Channel Setting 4 (Drac4)] - Mitsubishi Electric MELSERVO-J5 MR-J5-G Series User Manual

[Pr. PF89_Drive recorder - Analog channel setting 3 (DRAC3)]

Initial value
00090205h
[Pr. PF89.0-2_Drive recorder - Analog channel 5 selection]
Initial value
205h
Select the analog channel 5 of the drive recorder.
The servo parameter is disabled in the following conditions.
• [Pr. PF80.0] is set to "0" (Automatic setting mode)
Refer to the following for values that can be assigned.
Page 93 [Pr. PF87.0-2_Drive recorder - Analog channel 1 selection]
[Pr. PF89.4-6_Drive recorder - Analog channel 6 selection]
Initial value
009h
Select the analog channel 6 of the drive recorder.
The servo parameter is disabled in the following conditions.
• [Pr. PF80.0] is set to "0" (Automatic setting mode)
Refer to the following for values that can be assigned.
Page 93 [Pr. PF87.0-2_Drive recorder - Analog channel 1 selection]

[Pr. PF90_Drive recorder - Analog channel setting 4 (DRAC4)]

Initial value
0000000Ch
[Pr. PF90.0-2_Drive recorder - Analog channel 7 selection]
Initial value
00Ch
Select the analog channel 7 of the drive recorder.
The servo parameter is disabled in the following conditions.
• [Pr. PF80.0] is set to "0" (Automatic setting mode)
Refer to the following for values that can be assigned.
Page 93 [Pr. PF87.0-2_Drive recorder - Analog channel 1 selection]
Setting range
00000000h to 02FF02FFh
Setting range
000h to 2FFh
Setting range
000h to 2FFh
Setting range
00000000h to 000002FFh
Setting range
000h to 2FFh
Setting method
Each axis
Supported software version
A0
Supported software version
A0
Setting method
Each axis
Supported software version
A0
1 DETAILED LISTS OF SERVO PARAMETERS
1.7 Extension setting 3 servo parameters group ([Pr. PF_ _ ])
Supported software version
Refer to each detail No.
Supported software version
Refer to each detail No.
1
95