[Pr. Npa02_Ip Address]; [Pr. Npa04_Subnet Mask] - Mitsubishi Electric MELSERVO-J5 MR-J5-G Series User Manual

Ac servo system
Hide thumbs Also See for MELSERVO-J5 MR-J5-G Series:
Table of Contents

Advertisement

Setting value
"00000001h" (Network
parameters are used.)
The initial value of the IP address is as follows.
Item
IP address
Subnet mask

[Pr. NPA02_IP address]

Initial value
192.168.3.1 (C0A80301h)
TSN
A0
Set the address in hexadecimal. In eight digits of a hexadecimal, the first to forth octets are expressed in each pair of digits
shown below.
Two
Two
Two
Two
digits
digits
digits
digits
Set the IP address assigned by the network administrator.
Refer to the following for the relation to the rotary switch.
Page 137 [Pr. NPA01_IP address setting]
When SLMP command (IPAddressSet) is received at the time of IP address delivery from the controller, this network
parameter is overwritten with the received IP address.
To enable this network parameter, cycle the power or reset the software after setting.

[Pr. NPA04_Subnet mask]

Initial value
255.255.255.0 (FFFFFF00h)
TSN
A0
Set the subnet mask in hexadecimal.
In the eight digits of hexadecimal, the first to forth octets are expressed with each pair of digits shown below.
Two
Two
Two
Two
digits
digits
digits
digits
Set the subnet mask assigned by the network administrator.
When SLMP command (IPAddressSet) is received, this network parameter is overwritten with the received subnet mask.
To enable this network parameter, cycle the power or reset the software after setting.
5 Detailed list of the network parameters
138
5.1 Network basic parameters
Rotary switches (SW1/SW2) IP address
Setting range
00000000h to FFFFFFFFh
4th octet
3rd octet
2nd octet
1st octet
Setting range
00000000h to FFFFFFFFh
4th octet
3rd octet
2nd octet
1st octet
1st octet
The 1st octet of the setting value in [Pr. NPA02] is used.
2nd octet
The 2nd octet of the setting value in [Pr. NPA02] is used.
3rd octet
The 3rd octet of the setting value in [Pr. NPA02] is used.
4th octet
The 4th octet of the setting value in [Pr. NPA02] is used.
Initial value
192.168.3.1
255.255.255.0
IP
A0
IP
A0
Size
4 bytes
Size
4 bytes

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melservo-j5 mr-j5w-g series

Table of Contents