Pr. Pl18_Magnetic Pole Detection - Minute Position Detection Method - Identification Signal Amplitude (Idlv - Mitsubishi Electric MELSERVO-J5 MR-J5-G Series User Manual

[Pr. PL17.1_Load to motor mass ratio/load to motor inertia ratio selection]
Initial value
0h
Select a load to mass of the linear servo motor primary-side ratio or load to mass of the direct drive motor inertia ratio used for
the minute position detection method. Select a value closest to the actual load.
Refer to the following table for setting values.
[Pr. PL17.1] setting value
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
[Pr. PL18_Magnetic pole detection - Minute position detection
method - Identification signal amplitude (IDLV)]
Initial value
0 [%]
Set an identification signal amplitude to be used in the minute position detection method.
This servo parameter is enabled when [Pr. PL08.0 Magnetic pole detection method selection] is set to "4".
When "0" is set, the amplitude will be 100 [%].
Setting range
0h to Fh
Setting range
0 to 200
1.8 Motor extension setting servo parameters group ([Pr. PL_ _ ])
Supported software version
A0
Load to motor mass ratio/load to motor inertia ratio
10 times or less
10 times
20 times
30 times
40 times
50 times
60 times
70 times
80 times
90 times
100 times
110 times
120 times
130 times
140 times
150 times or more
Setting method
Each axis
1 DETAILED LISTS OF SERVO PARAMETERS
Supported software version
A0
103
1