[Pr. Pt17_Software Position Limit - (Lmn)]; [Pr. Pt29_Function Selection T-3 (*Top3)]; [Pr. Pt41_Function Selection T-8 (Top8)] - Mitsubishi Electric MELSERVO-J5 MR-J5-G Series User Manual

[Pr. PT17_Software position limit - (LMN)]

Initial value
0 [Refer to the text]
Set an address decreasing side of the software position limit.
The other specifications are the same as [Pr. PT15].

[Pr. PT29_Function selection T-3 (*TOP3)]

Initial value
00000000h
[Pr. PT29.0_Device input polarity 1]
Initial value
0h
Select the proximity dog input polarity.
0: Dog detection with off
1: Dog detection with on

[Pr. PT41_Function selection T-8 (TOP8)]

Initial value
00000000h
[Pr. PT41.0_Homing prohibition selection]
Initial value
0h
0: Disabled
1: Enabled
When "1" is set, the homing is not performed even if the start signal is turned on in the homing mode.
1 DETAILED LISTS OF SERVO PARAMETERS
106
1.9 Positioning control setting servo parameter group ([Pr. PT_ _])
Setting range
-2147483648 to 2147483647
Setting range
00000000h to 00000001h
Setting range
0h to 1h
Setting range
00000000h to 00000001h
Setting range
0h to 1h
Setting method
Each axis
Setting method
Each axis
Supported software version
A0
Setting method
Each axis
Supported software version
A0
Supported software version
A0
Supported software version
Refer to each detail No.
Supported software version
Refer to each detail No.