Shutdown (Vrrp) - Cisco Nexus 3548 Command Reference Manual

shutdown (VRRP)

shutdown (VRRP)
To disable a Virtual Router Redundancy Protocol (VRRP) configuration, use the shutdown command.
To enable a VRRP configuration, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default Disabled
Command Modes VRRP configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines Shut down the virtual router before configuring the virtual router parameters; you can only configure the
virtual router after it is in the administrative shut down state. Enter the no shutdown command to update
the virtual router state after completing configuration.
This command requires the LAN Base Services license.
Examples This example shows how to shut down a VRRP group:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# vrrp 45
switch(config-if-vrrp)# shutdown
switch(config-if-vrrp)# address 6.6.6.45
switch(config-if-vrrp)# no shutdown
switch(config-if-vrrp)#
Related Commands Command
feature vrrp
show vrrp
clear vrrp
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
358
shutdown
no shutdown
Modification
This command was introduced.
Description
Enables VRRP.
Displays VRRP configuration information.
Clears all the software counters for the specified virtual router.
Chapter Unicast Routing Commands
OL-27852-01