Clear Ip Eigrp Neighbors - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

clear ip eigrp neighbors

To remove and reestablish the Enhanced Interior Gateway Routing Protocol (EIGRP) neighbor entries
from the appropriate table, use the clear ip eigrp neighbors command.
Syntax Description *
ip-address
ethernet slot/port
loopback if_number
port-channel number
soft
vrf vrf-name
all
default
management
Command Default
When no autonomous system number, interface, or VRF instance is specified, all EIGRP neighbor
entries are cleared from the table.
Command Modes Any command mode
Command History Release
5.0(3)A1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples This example shows how to clear all EIGRP entries for neighbors on Ethernet interface 2/1:
switch# clear ip eigrp neighbors ethernet 2/1 vrf *
OL-27852-01
clear ip eigrp neighbors [* | ip-address | ethernet slot/port | loopback if_number | port-channel
number] [soft] [vrf {vrf-name | all | default | management}]
Modification
This command was introduced.
(Optional) Clears all neighbors.
(Optional) Address of the neighbor.
(Optional) Clears the Ethernet interface from the neighbor table. The
slot number is from 1 to 255, and the port number is from 1 to 128.
(Optional) Clears the loopback interface from the neighbor table. The
loopback interface number is from 0 to 1023.
(Optional) Clears the EtherChannel interface and EtherChannel
number from the neighbor table. The range is from 1 to 4096.
(Optional) Specifies soft reset for the neighbors.
(Optional) Specifies a virtual routing and forwarding (VRF) instance.
The VRF name is an alphanumeric string of up to 32 characters.
(Optional) Clears the EIGRP neighbor information from all VRF
instances.
(Optional) Clears the EIGRP neighbor information from the default
VRF.
(Optional) Clears the EIGRP neighbor information from the
management VRF.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
clear ip eigrp neighbors
77