Set Tag - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

set tag

To set a tag value of the destination routing protocol, use the set tag command. To delete the entry, use
the no form of this command.
Syntax Description
tag-value
Command Default If not specified, the default action is to forward the tag in the source routing protocol onto the new
destination protocol.
Command Modes Route-map configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines Use the route-map global configuration command and the match and set route-map configuration
commands to define the conditions for redistributing routes from one routing protocol into another. Each
route-map command has a list of match and set commands associated with it. The match commands
specify the match criteria—the conditions under which redistribution is allowed for the current
route-map command. The set commands specify the set actions—the particular redistribution actions
to perform if the criteria enforced by the match commands are met. The no route-map command deletes
the route map.
The set route-map configuration commands specify the redistribution set actions to be performed when
all the match criteria of a route map are met. When all match criteria are met, all set actions are
performed.
This command requires the LAN Enterprise Services license.
Examples This example shows how to set the tag value of the destination routing protocol to 5:
switch# configure terminal
switch(config)# route-map test
switch(config-route-map)# set tag 5
switch(config-route-map)#
OL-27852-01
set tag tag-value
no set tag tag-value
Modification
This command was introduced.
Name for the tag. The value is an integer from 0 to 4294967295.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
set tag
351