Transmit-Delay (Ospf Virtual Link); Related Commands - Cisco Nexus 3548 Command Reference Manual

transmit-delay (OSPF virtual link)

transmit-delay (OSPF virtual link)
To set the estimated time required to end a link-state update packet on the interface, use the
transmit-delay command. To return to the default, use the no form of this command.
Syntax Description
seconds
Command Default
1 second
Command Modes Virtual interface configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines This command requires the LAN Enterprise Services license.
Examples This example sets the retransmit delay value to 3 seconds:
switch# configure terminal
switch(config)# router ospf 201
switch(config-router)# area 22 virtual-link 192.0.2.1
switch(config-router-vlink)# transmit-delay 3
switch(config-router-vlink)#

Related Commands

Command
show ip ospf traffic
show ip ospf
virtual-links
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
396
transmit-delay seconds
no transmit-delay
Time (in seconds) required to send a link-state update. The range is from
1 to 65535 seconds. The default is 1 second.
Modification
This command was introduced.
Description
Displays OSPF traffic statistics.
Displays parameters and the current state of OSPF virtual links.
Chapter Unicast Routing Commands
OL-27852-01