Hardware Ip Glean Throttle Maximum - Cisco Nexus 3548 Command Reference Manual

hardware ip glean throttle maximum

hardware ip glean throttle maximum
To limit the maximum number of drop adjacencies that will be installed in the Forwarding Information
Base (FIB), use the hardware ip glean throttle maximum command. To apply the default limits, use
the no form of this command.
Syntax Description
count
Command Default
1000 entries
Command Modes Global configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines Before you use this command, make sure that you enable the IP glean throttle feature by using the
hardware ip glean throttle command.
If the maximum number of entries are exceeded, the packets for which ARP is not resolved continue to
be processed in the software instead of getting dropped in the hardware.
This command does not require a license.
Examples This example shows how to limit the maximum number of drop adjacencies that are installed in the FIB:
switch# configure terminal
switch(config)# hardware ip glean throttle maximum 16383
switch(config)#
Related Commands Command
hardware ip glean
throttle
show running-config
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
134
hardware ip glean throttle maximum count
no hardware ip glean throttle maximum
Maximum count. The range is from 0 to 16383.
Modification
This command was introduced.
Description
Enables the IP glean throttle feature.
Displays information about the running configuration.
Chapter Unicast Routing Commands
OL-27852-01