Ip Offset-List Eigrp - Cisco Nexus 3548 Command Reference Manual

ip offset-list eigrp

ip offset-list eigrp
To configure an offset list for the Enhanced Interior Gateway Routing Protocol (EIGRP) on an interface,
use the ip offset-list eigrp command. To restore the default, use the no form of this command.
Syntax Description
instance-tag
prefix-list list-name
route-map map-name
in
out
offset
Command Default
None
Command Modes
Interface configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines
Cisco NX-OS adds the configured offset value to any routes that match the configure prefix list or route
map. You must configure the named route map or prefix list to complete this configuration.
This command requires the LAN Base Services license.
Examples
This example shows how to configure an offset list filter to add 20 to the metric for EIGRP routes coming
into the interface that match the route map OffsetFilter:
switch# configure terminal
switch(config)# router eigrp 209
switch(config-router)# interface ethernet 2/1
switch(config-if)# no switchport
switch(config-if)# ip offset-list eigrp 209 route-map OffsetFilter in 20
switch(config-if)#
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
174
ip offset-list eigrp instance-tag {prefix-list list-name | route-map map-name} {in | out} offset
no ip offset-list eigrp instance-tag {prefix-list list-name | route-map map-name} {in | out} offset
Modification
This command was introduced.
Name of the EIGRP instance. The instance-tag can be any
case-sensitive, alphanumeric string up to 20 characters.
Specifies the name of an IP prefix list to filter EIGRP routes.
Specifies the name of a route map to filter EIGRP routes.
Applies the route policy to incoming routes.
Applies the route policy to outgoing routes.
Value to add to the EIGRP metric. The range is from 0 to
2147483647.
Chapter Unicast Routing Commands
OL-27852-01