Manually Assigning Ip Information To Multiple Svis - Cisco Catalyst 9500 Manual

Performing Device Setup Configuration
Step 3
Step 4
Step 5
Step 6

Manually Assigning IP Information to Multiple SVIs

This task describes how to manually assign IP information to multiple switched virtual interfaces (SVIs):
Procedure
Step 1
Step 2
Command or Action
boot host retry timeout timeout-value
Example:
Device(conf)# boot host retry timeout
300
banner config-save ^C warning-message ^C
Example:
Device(conf)# banner config-save ^C
Caution - Saving Configuration File
to NVRAM May Cause You to No longer
Automatically Download Configuration
Files at Reboot^C
end
Example:
Device(config-if)# end
show boot
Example:
Device# show boot
Command or Action
configure terminal
Example:
Device# configure terminal
interface vlan vlan-id
Example:
Device(config)# interface vlan 99
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
Manually Assigning IP Information to Multiple SVIs
Purpose
(Optional) Sets the amount of time the system
tries to download a configuration file.
If you do not set a timeout, the
Note
system will try indefinitely to
obtain an IP address from the
DHCP server.
(Optional) Creates warning messages to be
displayed when you try to save the
configuration file to NVRAM.
Returns to privileged EXEC mode.
Verifies the configuration.
Purpose
Enters global configuration mode.
Enters interface configuration mode, and enters
the VLAN to which the IP information is
assigned. The range is 1 to 4094.
65