To protect the boxes against pressure, use sufficiently long rope and a spreader beam. Please
proceed as follows:
1. Attach the rope/cable to the pallet as shown in the following diagram.
2. Attach the rope/cable to the spreader beam
3. Pay attention to the center of gravity imprinted on the box
4. Carefully raise the transportation unit.
4.4
Unpacking
4.4.1
Removing the packaging
NOTICE
Incorrect storage of unpacked devices
Proper packaging ensures that the equipment is protected. Unpackaged equipment may be
damaged if it is stored or out of service over a long period.
Carefully observe the instructions for storage in Chapters "Storage" and "Technical data and
drawings". Remove the packaging immediately prior to installation.
The units are packed by the manufacturers in accordance with the order.
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017
③
the ropes
.
①
Spreader beam
②
Center of gravity
③
Imprinted position of the rope
Figure 4-5
Transporting a transportation unit (still in packaging) with a crane
①
and the crane hook.
②
and the imprinted position of
Preparations for use
4.4 Unpacking
81