Operation Via The Aop30 Operator Panel; General Information About The Aop30 Operator Panel; Aop30 Operator Panel - Siemens SINAMICS GM150 Operating And Installation Instructions

Operation

8.2 Operation via the AOP30 operator panel

Exceeding the permitted short-circuit currents
Serious follow-on faults are possible, if the specified short-circuit current values are exceeded.
This can result in death, serious injury or material damage.
Observe the maximum permitted short-circuit currents and maximum specified short-circuit
times.
NOTICE
Incorrect parameterization
The drive may malfunction if you change the parameters.
Do not change the parameters, e.g. for the motor circuit-breaker.
Note
To complement these operating instructions, the List Manual contains an overview of all
parameters as well as a selection of function diagrams to describe the operating principle.
Only trained personnel should be allowed to operate the drive.
This section describes basic operating procedures performed via the AOP30 operator panel.
8.2 Operation via the AOP30 operator panel
8.2.1

General information about the AOP30 operator panel

8.2.1.1

AOP30 operator panel

You can use the Advanced Operator Panel (AOP30) for operating, and diagnosing the drive.
The AOP30 communicates with the drive via a serial RS-232 interface with PPI protocol. The
interface is a point-to-point connection. The AOP30 has the master function in this
communication. The connected drive has the slave function.
126
WARNING
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017