Figure 6-8 Connecting The External Encoder To The Smc30 Sensor Module - Siemens SINAMICS GM150 Operating And Installation Instructions

Electrical connection
6.5 Connection
3. Route the cables from the encoder into the cabinet from below.
4. Route the cable further up into the cabinet.
5. Connect the encoder cables
6. Connect the shield of the encoder cable directly to the shielding bus (serrated bar). It is
7. Attach the shield of the connecting cable to the module
114
important here to establish the greatest possible area of contact and a good conductive
connection.
secure the shield in place.
Figure 6-8 Connecting the external encoder to the SMC30 Sensor Module
①
to the SMC30 Sensor Module.
②
. Use metal ground clamps to
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017