Installation; Safety Instructions For Assembly - Siemens SINAMICS GM150 Operating And Installation Instructions

Installation

5.1

Safety instructions for assembly

Observe Chapter, "Safety instructions" when carrying out any work at the converter.
NOTICE
Improper installation
The devices can be damaged through improper installation.
Install the devices as described in the following sections. Take note of the ambient
temperatures stated in the technical specifications. Protect the drive against excessive stress
and loading.
Defective seals
When working on the device, seals at the doors, roof panels as well as front, rear and side
panels can be damaged. Operating the device with defective seals can result in death, serious
injury or material damage.
Replace the defective seals before commissioning. Observe the environmental conditions
stated in the technical data.
Dirt deposits during installation
Dirt gets deposited in the open converter during installation work. Dirt deposits can lead to
the converter no longer fulfilling the requirements for cleanliness. If the converter is operated
with internal pollution, death, serious injury and material damage can result.
Therefore, remove dirt deposits after installation. Then keep the doors closed.
In the event of contamination from conductive dust particles (e.g. from welding work),
professional cleaning will be required. Contact the service center in this regard.
NOTICE
Foreign bodies in the drive
If, after installation and maintenance work, foreign bodies are left in the drive, this can damage
it when switching on.
Before switching on, check as to whether there are any foreign bodies in the drive. Remove
any foreign bodies.
SINAMICS GM150 6SL3815-2LN41-4AA2
Operating Instructions 04/2017
WARNING
WARNING
5
87