Ricoh Pro C7100s Operating Instructions Manual page 66

2. Basic Copying
• Even if you place different size originals in the ADF, appropriate size of copy paper can be
automatically selected and stapled using the Mixed Sizes mode and Auto Paper Select function.
Load the paper you want to use in the paper trays beforehand.
• If the number of the sheets to be stapled as one set exceeds the capacity of the stapler, copies that
are not stapled will be delivered to the tray.
• To specify Left 2, Top 2, or Slant together with [2 Originals] or [8 Originals] of [Combine 1 Side],
or [4 Originals] or [16 Originals] of [Combine 2 Sides]: specify
originals and specify
• To specify Left 2, Top 2, or Slant together with Double Copies: specify
originals and specify
• When Left 2 or Top 2 is selected, the following settings are useful to rotate images appropriately:
• Auto Reduce / Enlarge or Auto Paper Select
• Replace [Auto Tray Switching] with [With Image Rotation] in User Tools.
• When Top 1 or Bottom 1 is selected and the paper with the same orientation as the original is not
loaded, the image is rotated and the paper with the same size and the different orientation is
selected. The maximum original image size that can be rotated is A4 or 8
• Depending on the settings for the Staple, you may not be able to use the Rotate Copy function.
• When the original image is rotated, the staple orientation changes by 90 degrees.
• If you select Staple: Center, you must specify the Magazine function. The machine staples the
paper, and folds it like a book, then delivers the paper folded. For details about the Magazine
function, see page 166 "Booklet/Magazine".
• When the number of copies exceeds tray capacity, copying stops. If this happens, remove the
copies from the finisher tray to resume copying.
• For details about the number of sheets that can be stapled together, the sizes, weights, and
orientations of paper that can be stapled, and the number of copy sheets that the output tray can
accommodate, see "Specifications", Maintenance and Specifications.
• You can change the staple positions shown on the initial screen using the [Input / Output] setting in
User Tools. You can also register staple positions on the [Finisher] tab. To select a staple position
not displayed on the initial screen, you need to specify one of these settings. For details about
staple positions, see page 246 "Input / Output".
Cutting the fore edge
Use this function to cut the fore edge of a document after it is saddle stitched or folded in half by the
finisher.
• This function is available only when you select Center as the stapling position or Half Fold under
[Finisher].
64
paper for orientation originals.
paper for orientation originals.
paper for orientation
paper for orientation
1
/ × 11.
2