Orientation-fixed (top to bottom) or two-sided paper might not be printed correctly depending on
how the originals and paper are placed. For details, see "Loading Orientation-fixed Paper or Two-
sided Paper", Paper Specifications and Adding Paper.
Fore Edge Cut Setting
Specify the length of the fore edge cut.
Specify the cut length from 2.0 to 20.0 mm (0.08 to 0.79 inches) in increments of 1 mm (0.01
inches). In case of B5 JIS size paper, the cut length is between 2.0 to 10.0 mm.
Default:
(mainly Europe and Asia)
[4.0 mm]
(mainly North America)
[0.16 inch]
Staple Position
Specify which staple type has priority to be shown on the initial screen.
• When Finisher SR5050 is installed:
Default for "Staple Position 1": [Staple: Slant]
Default for "Staple Position 2": [Staple: Bottom 1]
Default for "Staple Position 3": [Staple: Left 2]
Default for "Staple Position 4": [Staple: Top 2]
• When Booklet Finisher SR5060 is installed:
Default for "Staple Position 1": [Staple: Slant]
Default for "Staple Position 2": [Staple: Center]
Default for "Staple Position 3": [Staple: Left 2]
Default for "Staple Position 4": [Staple: Top 2]
Punch Type
Specify which punch type has priority to be shown on the initial screen.
• When 2 & 4 hole punch unit is installed:
Default for "Punch Type 1": [Punch: Left 2]
Default for "Punch Type 2": [Punch: Top 2]
• When 2 & 3 hole punch unit is installed:
Default for "Punch Type 1": [Punch: Left 3]
Default for "Punch Type 2": [Punch: Top 3]
Input / Output
247