Back Up Lamp Removal; Installation; Back Up Lamp Unit Removal; Brake Lamp Switch Description - Chrysler Concorde 2004 Service Manual

LH
LAMPS/LIGHTING - EXTERIOR (Continued)
LAMP
Tail/Brake/Turn
Signal
Tail
Underhood
BULB APPLICATION TABLE - EXPORT
LAMP
Back-up
CHMSL
Front Fog
Front Position
Front Turn Signal
Headlamps (High Beam)
Headlamps (Low Beam)
License Plate
Rear Fog
Rear Tail/Stop
Rear Turn Signal
Side Repeater
Underhood
Underhood Retractable
BACK UP LAMP
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove screws holding back up lamp unit to
bumper.
(3) Separate back up lamp unit from bumper.
(4) Rotate lamp socket counterclockwise one quar-
ter turn.
(5) Pull lamp socket from back of lamp unit.
(6) Pull lamp from lamp socket.

INSTALLATION

(1) Push lamp into lamp socket.
(2) Push lamp socket into back of lamp unit.
(3) Rotate lamp socket clockwise one quarter turn
until it stops.
(4) Position back up lamp unit into opening on
bumper.
(5) Install screws to hold back up lamp unit to
bumper.
(6) Connect the battery negative cable.
MODEL BULB
ALL except 3157K
Concorde
Concorde 3057K
Limited
Intrepid -
Police
BULB
P27/7W
W16W
H3 (55W)
W5W
P27/7W
9005 (HB3)
9006 (HB4)
W5W
P27/7W
P27/7W
P27/7W
W5W
W5W
105
BACK UP LAMP UNIT
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove screws holding back up lamp unit to
916
rear bumper.
154
(3) Disconnect the wire connector.
(4) Separate lamp unit from vehicle.
INSTALLATION
(1) Connect the one wire connector.
(2) Place back up lamp unit into opening in
bumper on vehicle.
(3) Install screws to hold back up lamp unit to
rear bumper.
(4) Connect the battery negative cable.
BRAKE LAMP SWITCH
DESCRIPTION
The brake lamp switch is located under the instru-
ment panel at the brake pedal arm (Fig. 1). This
switch contains three internal switches controlling
various functions of the vehicle, one of them controls
operation of the vehicle's brake lamps. Other func-
tions of the internal switches include speed control
deactivation and brake sense for the ABS and the
brake transmission shift interlock.
1 - STEERING COLUMN COUPLER
2 - BRAKE PEDAL
3 - SWITCH

OPERATION

The brake lamp switch has three internal switches
used for various functions. Among these are:
• Brake lamp actuation
LAMPS/LIGHTING - EXTERIOR 8L - 5
Fig. 1 BRAKE LAMP SWITCH