LH
FOG LAMP (Continued)
INSTALLATION
INTREPID/300M
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Connect wire connector to fog lamp wire har-
ness.
(2) Cover exposed terminal with teflon coated
sleeve.
(3) Insert bulb into lamp housing.
(4) Hinge wire clip over bulb base.
(5) Engage wire clip to hold bulb in fog lamp.
(6) Install rear cover to fog lamp housing.
(7) Verify fog lamp operation and alignment.
(8) Install fog lamp housing screw to the front fas-
cia.
CONCORDE
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Install socket into fog lamp housing and rotate
to the lock position.
(2) Connect wire connector to the socket.
(3) Verify fog lamp operation and alignment.
(4) Install fog lamp housing into fascia.
(5) Install fog lamp screw to the front fascia
1 - HORIZONTAL CENTER LINE OF FOG LAMPS
2 - TOP OF FOG LAMP BEAM PATTERN CUT OFF ± 4 INS. FROM
HORIZONTAL CENTER LINE
Fig. 14 FOG LAMP UNIT ALIGNMENT SCREEN
LAMPS/LIGHTING - EXTERIOR 8L - 13
FOG LAMP UNIT
STANDARD PROCEDURE - FOG LAMP UNIT
ALIGNMENT
Prepare an alignment screen (Fig. 14). Refer to
Electrical, Lamps/Lighting - Exterior, Headlamp,
Adjustments for Alignment Screen Preparation. A
properly aligned fog lamp will project a pattern on
the alignment screen 100 mm (4 in.) below the fog
lamp center line and straight ahead. To adjust fog
lamp alignment, rotate the alignment screw (Fig. 15),
(Fig. 16) or (Fig. 17).
Fig. 15 FOG LAMP UNIT ADJUSTER SCREW -
INTREPID
1 - FOG LAMP UNIT
2 - UP/DOWN ADJUSTER SCREW
3 - FRONT OF FOG LAMP
4 - 7.62 METERS (25 FT.)