Offset/Gain Setting Operation - Mitsubishi Q68TD-G-H01 User Manual

5
UTILITY PACKAGE (GX Configurator-TI)
5.6.2
Perform the offset/gain setting operation in the following sequence.
(1) Display the "CH
(2) Switch to the offset/gain setting mode
(3) Enable the Conversion enable/disable setting
(4) Adjustment of the offset and gain values
5
- 20 5.6 Monitoring/Test

5.6.2 Offset/gain setting operation

Offset/gain setting operation
Offset/gain setting" screen
Display the "CH Offset/gain setting" screen of the channel where offset/gain
setting will be made using the operation described in Section 5.6.1.
Note) Do not perform this operation when the setting has been changed to the
offset/gain setting mode.
Set "Offset/gain setting mode" in the Setting value field for "Mode Switching Setting
"and click the
Switching Setting Status" changes to "Offset/gain setting mode".
(a) Set "Enable" in the Setting value field for "Conversion enable/disable setting" and
click the
(b) Set "Request" in the Setting value field for "Operating condition setting request"
setting and click the
changes from "OFF" to "Request".
(c) Set "OFF" in the Setting value field for "Operating condition setting request"
setting and click the
changes from "Request" to "OFF".
(a) Adjust the offset setting value
1) Select the offset setting
Select "Offset setting" in the Setting value field for "CH
setting" and click the
2) Set the offset value
Enter the desired value into the Setting value field for "CH
temperature setting value", and click the
3) Determine the offset value
Select "Request" in the Setting value field for "CH
setting and click the
Confirm that "CH
"Completed", and then select "OFF" in the Setting value field of "CH
change request" and click the
Select "Invalid" in the Setting value field for "CH
setting" and click the
button. The indication in the Current value field of "Mode
button.
button. The indication in the Current value field
button. The indication in the Current value field
button.
button.
Channel change completion flag" has changed to
button.
Offset setting channel
Offset
button.
Channel change request"
button.
Offset setting channel
Channel