Hd Display Installation; Smart Hub Installation - Lennox iComfort S30 Installation And Setup Manual

HD DISPLAY INSTALLATION

1. Line up HD display with MAG-MOUNT base.
2. Insert bottom of the HD display at 30 degree angle into tabs at bottom of the
MAG-MOUNT wall base.
WITHOUT COVER
3. Rotate the HD display upward until it snaps into place by pressing on sides.
4. To remove HD display from MAG-MOUNT base simply rotate in either direction
the HD display 30 degrees and pull off. Failure to rotate display before
pulling off requires much more force to be used and may pull out wall
anchors.
NOTE: If the HD display is removed from the MAG-MOUNT base, the HD display
will shut down and not be able to communicate with the system. System can be
control from mobile devices or dealer web portal if registration has been completed.

SMART HUB INSTALLATION

1. Use the following procedure to install the Smart Hub controller. Refer to figures
3 through 11 for making control wiring connections.
2. Mount the Smart Hub near the indoor unit using field-provided fasteners.
USE SMART HUB AS TEMPLATE TO MARK DESIRED MOUNTING LOCATIONS ON WALL OR STUD.
CAUTION; DO NOT OVERTIGHTEN LOWER MOUNTING SCREW, MAY DAMAGE SMART HUB.
A
THROUGH-
HOLE
FRONT.
TABS
WITH COVER
KEYHOLE
.
REAR.
Figure 2. Smart Hub Controller Installation
3. Unfold both antennas to the vertical position. Adjustments may be required to
optimized transmitting and receiving.
NOTE - DO NOT mount the Smart Hub to indoor unit, duct work or equipment that
could induce vibration to the module. Mount Smart Hub on flat surface away from
indoor unit to minimize vibration. Securing module to a wall stud is desirable. If
mounted on metal surface other than above, antennas need to be perpendicular to
the metal surface.
TAB
Magnetic Field - Magnets located in this product have far-reaching, strong
magnetic fields. They could damage TVs and laptops, computer hard drives,
credit and ATM cards, data storage media, mechanical watches hearing aids and
speakers.
Keep HD Display away from devices and objects that could be damage by strong
magnetic fields.
SMART HUB
B STRIP 1/4" INSULATION FROM
END OF EACH CONTROL WIRE
1/4"
4
CAUTION
ACCESS COVER
SMART HUB WITHOUT
C
SECURE MAG-MOUNT TO WALL WITH
FIELD-PROVIDED FASTNERS
ACCESS COVER