Mag-Mount Leds; Hd Display External Components; Hd Display Installation - Lennox iComfort S30 Installation And Setup Manual

Mag-Mount LEDs

LED: A blue LED, mounted on the internal circuit board and is visible from
outside the Mag-Mount enclosure near the top-left corner when the HD Display
is off the Mag-Mount. The LEDs indicate the following status:
S
Steady - Mag-Mount is receiving power from the Smart Hub.
S
Flashing - Mag-Mount is receiving power from the Smart Hub but could
be experiencing one of the following conditions:
n
It is not communicating with the Smart Hub,
n
There has been a software error in the Mag-Mount processor,
n
There has been an internal hardware error in the Mag-Mount.
S
Off - Mag-Mount is not receiving power from the Smart Hub or there has
been a serious Mag-Mount internal hardware or software failure.

HD Display External Components

S
Proximity Sensor - Used when person approaches the HD Display. If the
HD Display in in screen saver mode and motion is detected, the unit will
exit the screen saver and return the HD Display o the home screen.
S
Power Button - Used for powering off and rebooting display for
troubleshooting purposes. Press and hold for five seconds to turn off
display unit. Press and hold for five seconds to turn on unit.
S
SD Card Connector - for future use.
S
USB Connector - for future use.
S
Speaker

HD Display Installation

Magnets located in this product have far-reaching and strong magnetic fields.
They could damage TVs and laptops, computer hard drives, credit and ATM
cards, data storage media, mechanical watches, hearing aids and speakers.
Keep HD Display and Mag-Mount away from devices and objects that could
be damaged by strong magnetic fields.
1. Line up HD Display with MAG-MOUNT base.
2. Insert bottom of the HD Display at 30 degree angle into tabs at bottom of
the MAG-MOUNT wall base.
WITHOUT COVER
3. Rotate the HD Display upward until it snaps into place by pressing on sides.
4. To remove HD Display from MAG-MOUNT base rotate in either direction
the HD Display 30 degrees and pull away from wall to remove. Failure to
rotate display before pulling off requires much more force to be used
and may pull out wall anchors.
NOTE - If the HD Display is removed from the MAG-MOUNT base, the HD
Display will shut down and not be able to communicate with the system. System
can be controlled from mobile devices or dealer web portal once registration
has been completed.
5. Do not remove the label covering the HD Display screen until after power
is applied to the system.
5
CAUTION
TABS
WITH COVER
TAB