Diagnostics; Installation Report; Information; Dehumidification Settings - Lennox iComfort E30 Installation And Setup Manual

Diagnostics

This screen allows the installer to verify the current operational state of the air
handler or furnace. Diagnostics results are for active various inputs, voltage,
delays and relays.
Touch the left arrow at the top left side of screen to return to the Dealer Control
Center.

Installation Report

• Overview: The overview screen provides information on dealer and customer
information. Also included under day of install section is information on
conditions at the time of installation. Information includes date, time indoor
and outdoor temperatures and indoor humidity.
• System: Information to complete is System name, model number and other
system information.
• Indoor Unit (air handler / furnace): name, model number, serial and other

information.

NOTE: Installation Report is not available until after exiting the dealer control
center following commissioning. Return to the Dealer Control Center
from the home screen to view the installation report.
Results of both manual and automatic tests will be displayed under this section.
Information
The dealer information screen will appear. The next screen will be for dealer
information. Here either the dealer ID or phone number can be added. Once the
system is connected to the Internet, the remaining information is automatically
populated. Not all information for this screen will be viewable. Touch and hold
and then swipe up to access the remaining information on the screen.
Information Required: Dealer ID and / or dealer phone number. Information
that can be manually entered is name, email website, dealer address which
includes address 1, address 2, city state and zip/postal code. Once completed,
touch the left arrow at the top left side of screen to return to the Dealer Control
Center.
IMPORTANT
Adding dealer information will ensure the thermostat is associated with your
LennoxPros.com account when connecting to the Lennox server.
Information Pop-Up Screen: If the dealer ID or phone number is not provided,
a warning screen will appear. The warning screen will provided information on
the limitation imposed on the system if this information is missing. Touch no to
return to the above screen to complete the information requested or press yes
to continue.
General Information
On this screen general information needs to be verified or changed. Touch
any item to change its contents. A pop-up screen will appear that will allow the
information to be added or changed.
Information Required:
1. Select desired language (ENGLISH, FRANÇAIS, ESPAÑOL).
2. Select country / region.
3. Select time and date which includes time, date, time zone, daylight savings
time (ON/OFF)
NOTE: When connected to INTERNET, then time and date can not be changed.
If the time and date is incorrect then turn off Wi-Fi and correct then turn
Wi-Fi back on.
4. Temperature unit (Fahrenheit or Celsius).
5. Once completed press continue.
On this screen general information needs to be verified or changed. Touch any
line item to change its contents. Information to be added is address 1, address
2, state, city and zip/postal code.
Complete the requested information and press the continue button.

Dehumidification Settings

For firmware version 3.15 and later, all controls for dehumidification are listed
at menu > settings > humidity. Under Humidity Control, select dehumidify
to enable dehumidification. By default it is disabled.
When dehumidify is enabled, the options are as follows and are dependent on
equipment type and accessory installed.

Dehumidification Setting Options

• Normal — Recommend when the air outside is not too humid.
• Max —
» Single and Two-Stage Outdoor Units or Variable Capacity outdoor
units without a Discharge Air Temperature Sensor (DATS)
Installed. Recommend when outdoor air is excessively humid.
May cool your home below the set temperature.
28
Home Address