Outputs - Extron electronics PVS 407D User Manual

B
Inputs 5 and 6
(such as an Extron ShareLink device) to these female HDMI digital video connectors.
Use the Extron LockIt device to secure the HDMI cable at the switcher (see
the HDMI Cable
C
Input 7
analog audio signal from an output source such as an iPod or an MP3 player.
Connect a cable from the source to this 5-pole captive screw connector. It can be
wired as balanced or unbalanced (see
wiring details).
D
Aux audio port
connector for dedicated mono audio only input.
E
VoiceLift port
VLR 302 VoiceLift Receiver for integration of a VoiceLift Microphone system.
NOTE: To install the VoiceLift Microphone system, see the VoiceLift Installation
Guide, supplied with the device.
F
Paging sensor port
PPS 25) to this port, to enable program audio interruptions during paging system
broadcasts.
NOTE: The Extron Priority Page Sensor is an optional accessory, purchased
separately. See the Extron
To install a Priority Page Sensor system, see the installation guide supplied with
the applicable device.

Outputs

G
HDMI video output
video output connector. Use the Extron LockIt device to secure the HDMI cable at the
switcher (see
H
Line out audio output
assisted listening device to this 3.5 mm captive screw 5-pole connector.
I
Amplified audio output
connector. The amplified audio is capable of outputting 50 watts (2 x 25 watts RMS)
for 4 and 8 ohm speakers (see
(see Figure 2 on previous page) — Connect up to two HDMI sources
on page 8 for securing the cable).
— Input 7 is a dedicated audio-only input for an auxiliary, stereo, line-level
— Connect an aux audio device to this 3.5 mm captive screw 3-pole
— This RJ-45 jack is dedicated for use with the optional VLR 102 or
— Connect the optional Priority Page Sensor (PPS 35 or
website
— Connect a suitable display device to this female HDMI digital
Securing the HDMI Cable
— Connect an external amplifier, recording, podcasting, or
— Connect speakers to this 5 mm captive screw 4-pole
Speaker
PVS 407D Switcher • Rear Panel Connections
Input 7 Connector Wiring, page 78, for
for details about the Priority Page Sensors.
on page 8 for securing the cable).
Configuration, page 71, for wiring details).
Securing
5