Extron electronics PVS 407D User Manual page 58

Input/Output
To configure audio inputs and outputs:
1. Using the input buttons in the AV Controls panel to the left, select the applicable
input.
2. Click and drag the handle of the Input Gain slider, or click the up > and down <
arrows in the field below the slider, or enter a value in the field.
NOTES:
• You can only adjust the gain and attenuation for an input that is in analog or
Auto format. Gain only affects analog inputs.
• The Peak, Normal, or Signal LEDs light when each threshold is reached as
the input gain is adjusted (see X%
signal threshold).
3. Click and drag the handle of the Bass slider, or click the up > and down < arrows in
the field below the slider, or enter a value in the field.
4.
Click and drag the handle of the Treble slider, or click the up > and down < arrows
in the field below the slider, or enter a value in the field.
5. Select the Output mode (Dual Mono or Stereo) or the Line Out mode (Variable
or Fixed) for volume adjustment.
6. Click and drag the handle of the Volume slider or click the up > and down < arrows
in the field below the slider, or enter a value in the field.
Mic/Aux/Paging
Using this page to set the input gain, and where desired, ducking can be enabled
and settings configured for both VoiceLift and Aux inputs. In addition the Page Sensor
sensitivity and hold time can be set from this page.
Figure 34. Audio Configuration Page — Mic/Aux/Paging
To set VoiceLift or Aux input gain and ducking settings:
To adjust audio input gain (-18 to +24 dB), click and drag the handle of the Input Gain
slider, or click the up and down arrows in the field below the slider, or enter a value in the
field. The Peak, Normal, or Signal LEDs light when each threshold is reached as the input
gain is adjusted (see X% on page 20
PVS 407D • Using Extron Product Configuration Software
on page 20 for details on each type of
for signal thresholds).
52