Creating A Tie; Viewing Ties (And Muting Outputs); Saving Or Recalling A Preset; Locking Out The Front Panel (Executive Mode) - Extron electronics Fiber Matrix 6400 Setup Manual

Front Panel Operation

Creating a Tie

1. Press and release the Esc button to clear any input button,
output button, or control button indicators that may be lit.
2. Press and release the desired input button.
The button lights to indicate the selection.
5
3. Press and release the desired output button(s).
The output buttons blink to indicate the potential ties.
3 4 8
4. Press and release the Enter button. All button indicators
turn off.

Viewing Ties (and Muting Outputs)

1. Press the View button. Output buttons light for outputs
that have no ties established.
N If an output button blinks, that output is muted. To
toggle mute on and off, press and hold the output button
for 2 seconds.
2. Press an input button. The buttons for all tied outputs
light.
3. Press an output button. The buttons for the tied input and
all tied outputs light.
4. Press the View button. All input and output buttons return
to an unlit state.
3-2 Fiber Matrix 6400 Switcher • Front Panel Operation
Refer also to the Fiber Matrix 6400 Switcher User's Manual at www.extron.com.
ENTER
The Enter button blinks to indicate
the need to confirm the change.

Saving or Recalling a Preset

1. Save a preset — Press and hold the Preset button until it
flashes.
Save a
2 seconds
PRESET
preset
Press and hold.
Recall a preset — Press and release the Preset button.
Recall a
PRESET
preset
Press and release.
All input and output buttons with assigned presets light red.
When a preset is saved, the configuration data at
assigned preset locations will be overwritten.
1 2 3 4 5 6 7
2. Press and release the desired input or output button.
The button blinks red to indicate that
this preset is selected to save or recall.
1
ENTER
3. Press and release the Enter button.

Locking Out the Front Panel (Executive Mode)

To toggle the lock on and off, simultaneously press and hold the
Enter button and the Esc button for approximately 2 seconds.
Press and hold the Enter and
Esc buttons simultaneously to
toggle executive mode on or off.
C O N T R O L
2 seconds
ENTER PRESET VIEW ESC
Fiber Matrix 6400 Switcher • Front Panel Operation
Refer also to the Fiber Matrix 6400 Switcher User's Manual at www.extron.com.
PRESET
Preset button blinks.
PRESET
The Preset button lights.
INPUTS
The Enter button blinks
red to indicate the need to
activate the save or recall.
C O N T R O L
ENTER PRESET VIEW ESC
The Preset and View buttons
blink twice to indicate the
mode change.
Release the buttons.
3-3