Extron electronics PVS 407D User Manual page 37

Command
Set audio output mode
Set audio output mode to dual
mono
Set audio output mode to
stereo
View audio output mode
Paging Sensor hold time
Set Paging Sensor hold time
View Paging Sensor hold time
Paging Sensor sensitivity
Set Paging Sensor sensitivity
View sensitivity
RS-232 Serial port parameters
Configure RS-232 seral port
parameters
View RS-232 seral port
parameters
X10#
0
KEY: = Baud rate
1 = 19200
Information request
Request A/V input number
X!
KEY: = Input selection
Query model name
Query model description
Query system-memory usage
Query user-memory usage
Query firmware version
Query full firmware version
ASCII Command Response
(host to switcher) (switcher to host)
18*1#
PreAmpMod*1
18*2#
PreAmpMod*2
18#
PreAmpMod*X
75*X#
PageDly*X
75#
PageDly*X
83*X#
PageSen*X
83#
PageSen*X
E X10# }
CP Ccp
E } X10#]
CP
Verbose mode 2/3
Ccp
= 9600 (Default)
I
Vid •
1-7
1I PVS 407D]
Inf01*PVS 407D]
Verbose mode 2/3
2I PoleVault Digital
Switcher with Ethernet
Control]
Inf02*PoleVault Digital
Verbose mode 2/3
Switcher with Ethernet
Control]
3I # Bytes Used out of #
KBytes]
Inf03*# Bytes Used out of
Verbose mode 2/3
# KBytes]
4I
# Bytes Used out of #
KBytes]
Inf04*# Bytes Used out of
Verbose mode 2/3
# KBytes]
Q x.xx]
*Q x.xx.xxxx]
]
]
]
]
]
]
]
X10#]
X10#]
2 = 38400
3 = 115200
X! X!
• Aud • ]
PVS 407D • SIS Communication and Control
Additional Description
Where 1 = dual mono (default).
Where 2 = stereo.
Where X = 1 (dual mono, default) or 2
(stereo).
X = paging hold time in seconds, in 1
second steps.
0 = 0 second (disabled),
1 = 1.0, 2 = 2.0, ...
8 = 8.0 seconds; default is 3.0
seconds.
Where X = 0-100 (paging sensor
sensitivity range); default = 50.
Set the baud rate for the RS-232 port.
Query the baud rate for the
RS-232 port.
Reports input number for active video
and audio signals.
Reports model name.
View firmware version.
View full firmware version.
31