Table of Contents
Advertisement
LPOD-R Outdoor Amplifier / Block Up Converter (BUC)
Optional Serial Interface Operation (PS 1, PS 1.5 ONLY)
Controller-to-Target
Instruction Code and
Parameter Type
Qualifier
(* indicates
End-of-Life)
Command
Query
Number of
N/A
NUS?
Unread stored
Statistics
Part Number
N/A
PNM?
Retrieve Alarm
N/A
RAS?
Status
Arguments for
Command or
Response to
Query
3 bytes
Query only.
Unit returns the Number of Unread stored Statistics in the form xxx.
EXAMPLE: <0001/NUS?{CR}
>0001/NUS=126{CR}{LF}
96 bytes
Query only.
alphanumeric
Returns the DOTCODE string that is loaded into the unit.
EXAMPLE: <0001/PNM?{CR}
>0001/PNM=HPODC0.350WRSW00{CR}{LF}
168 bytes
Query only.
Returns the Alarm status of the unit, where:
OK = No fault condition; FT = Faulted; AL = Alarm; YS = Yes; NO = No; MS = Masked.
EXAMPLE:
<0001/RAS?{CR}
>0001/RAS={CR}
P24V1=OK{CR} (+24V power supply)
P24V2=NA{CR} (+24V switch power supply) (NOT USED)
LNBVT=XXXXX{CR} (+13/18V LNB power supply) (NOT USED)
P13VT=OK{CR} (+13.5V power supply)
P10V1=OK{CR} (+10V power supply)
A10V1=OK{CR} (+10V1 RF supply)
A10V2=NA{CR} (+10V2 RF supply) (NOT USED)
P7V8T=OK{CR} (+7.8V power supply)
P5V8T=OK{CR} (+5.8V power supply)
P2V5T=OK{CR} (+2.5V power supply)
P1V2T=OK{CR} (-1.2V power supply)
N5V8T=OK{CR} (-5.8V power supply)
FANR1 = OK{CR} (Fan 1 speed)
FANR2=OK{CR} (Fan 2 speed) (PS 1.5 ONLY)
ATEMP=OK{CR} (Amplifier temperature)
SHTDN=OK{CR} (Over-temp shutdown)
IICST=OK{CR} (I2C bus status)
FWPWR=OK{CR} (Forward power in dBm)
CHKSM=OK{CR} (Flash checksum)
FPGAD=NA{CR} (FPGA done status) (NOT USED)
BUCLD=OK{CR} (BUC lock detect) (NOT USED)
REFLD=NA{CR} (Reference lock detect) (NOT USED)
LNBCS=XXXXX{CR} (LNB current status) (NOT USED)
SWITC=NA{CR} (Waveguide switch position status) (NOT USED)
RDLNK=NA{CR} (Redundant link status) (NOT USED)
TRMST=YS{CR}{LF} (Terminal Status)
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
5–17
MN-LPODR
Revision 3
Target-to-Controller
(see Description of Arguments)
Response to
Response to
Command
Query
NUS=
NUS=xxx
PNM=
PNM=x....x
PNM?
PNM *
RAS=
RAS=x....x
Advertisement
Table of Contents
