Lpod-R Startup; Set The Lpod-R Power On; Monitoring Lpod-R Operation With The Led Indicator (Ps .5 Only); Figure 2-13. Lpod-R Ps .5 Led Indicator - Comtech EF Data LPOD-R PS .5 Installation And Operation Manual

LPOD-R Outdoor Amplifier / Block Up Converter (BUC)
System Connectors, Installation, and Startup

2.5 LPOD-R Startup

2.5.1

Set the LPOD-R Power ON

WARNING!
FOR SAFETY REASONS, NEVER TURN THE UNIT ON WITHOUT PROPER
WAVEGUIDE TERMINATION ON THE 'J2 | RF OUT' PORT. INDIVIDUALS
CAN BE EXPOSED TO DANGEROUSLY HIGH ELECTROMAGNETIC LEVELS.
The LPOD-R does not have a 'Power On/Off' switch. You may power ON the unit
by connecting the 'J3 | POWER IN' connector to the appropriate prime power
source. The Mute or Transmit status of the unit automatically comes up in the
last stored state (factory default = Transmit on, not muted).
2.5.2 Monitoring LPOD-R Operation with the LED
Indicator (PS .5 ONLY)
The LPOD-R PS .5 unit features a multi-color Light-Emitting Diode (LED) Indicator.
This LED is located on the signal output side of the LPOD-R PS .5 housing, next to
the ground lug. See Figure 2-13.
Upon power-up of the unit, this LED provides visual cues as to the operational
status and LO setting for the system. See Table 2-7 for details.

Figure 2-13. LPOD-R PS .5 LED Indicator

2–23
MN-LPODR
Revision 3