Omron CS1W-LC001 Operation Manual page 74

Basic Procedure for Using the Loop Control Unit
3. Setting up the Loop Control Unit
54
4) Set the ITEMs in each function block.
(If necessary, program step ladder commands in the Step Ladder Program
block including contact signals.)
Refer to CX-Process Tool Operation Manual.
Refer to the Function Block Reference Manual.
Note Set function block initial setting parameters (refer to the item "(S): Initial
setting data" describing how to read/write in the Function Block Reference
Manual) on CX-Process Tool.
5) Using CX-Process Monitor
Set the Terminals to Personal Computer for CX-Process Monitor.
Set the monitor tags for CX-Process Monitor and create the monitor tag
files.
Refer to the CX-Process Monitor Operation Manual.
OR
5) Using SCADA Software
Set the Send All Blocks, Receive All Blocks, or Expanded CPU Unit
Terminal blocks.
Set the CSV tags and create the CSV tag files.
Refer to the CX-Process Monitor Operation Manual.
1) Mount the Loop Control Unit and wire the Analog Input and Output Units.
The Loop Control Unit itself need not be wired.
See 2-2 Installation and refer to the manual for other Analog Input and
Output Units.
2) Set the unit number setting switch on the front panel of the Loop Control
Unit.
See 2-1 Names and Functions of Parts.
Refer to the Analog Input and Output Unit Manuals.
3) Connect the Programming Devices.
Refer to Programming Devices (CX-Programmer or Programming
Console) Operation Manual.
4) Turn power ON to the PC.
5) Create I/O tables using the Programming Devices.
Section 1-5