Omron CS1W-LC001 Operation Manual page 166

Simple Example of Use
Step 5 Trial Operation
1, 2, 3...
Step 6 Actual Operation
1. Execute the run/stop command on CX-Process Tool ([Execute]-[Run]-
[Run/Stop Command]) or turn the PC OFF then back ON again.
2. Check system operation on CX-Process Tool. ([Execute]-[Run]-[Monitor
run status])
Execute the load rate check and other diagnostic checks.
3. Check the wiring on CX-Process Tool. ([Validate Action]-[Start])
4. Set up and start CX-Process Monitor.
5. Set the Set Point and other settings on CX-Process Monitor.
1. Tune the Loop Control Unit on CX-Process Monitor. (For example, change
the settings and PID constants.)
2. Monitor PV and alarms on CX-Process Monitor.
Section 4-1
149