Omron CS1W-LC001 Operation Manual page 250

List of Operation Execution Times
List of Operation Execution Times for Function Blocks
Block
Block name
model
000 System Common
001 2-position ON/FF
002 3-position ON/OFF
011 Basic PID
012 Advanced PID
013 Blended PID
014 Batch Flowrate Capture
016 Fuzzy Logic
031 Indication and Setting
032 Indication and Operation
033 Ratio Setting
034 Indicator
045 ES100X Controller Terminal
4-point Warning Indicator
110
111 High/Low Alarm
112 Deviation Alarm
113 Rate-of-change Operation and
Alarm
115 High/Low Limit
116 Deviation Limit
118 Analog Signal Hold
121 Addition or Subtraction
122 Multiplication
123 Division
126 Arithmetic Operation
127 Range Conversion
131 Square Root
132 Absolute Value
133 Non-linear Gain (Dead Band)
134 Low-end Cutout
135 Segment Linearizer
Operation
execution time
1.05 The load rate increases by 0.40% at an operation
cycle of 100 ms.
0.74
0.77
1.61
1.84
1.79 The operation execution time of this function block
increased by 0.16 ms when the Loop Controller Unit
was upgraded from version 2.00 to 2.50.
1.05 The operation execution time of this function block
increased by 0.13 ms when the Loop Controller Unit
was upgraded from version 1.50 to 2.00.
11.10
0.71 The operation execution time of this function block
increased by 0.12 ms when the Loop Controller Unit
was upgraded from version 1.50 to 2.00.
0.86 The operation execution time of this function block
increased by 0.22 ms when the Loop Controller Unit
was upgraded from version 1.50 to 2.00.
0.80 The operation execution time of this function block
increased by 0.19 ms when the Loop Controller Unit
was upgraded from version 1.50 to 2.00.
0.58 The operation execution time of this function block
increased by 0.15 ms when the Loop Controller Unit
was upgraded from version 1.50 to 2.00.
2.00
0.58
0.39
0.49
0.49
0.40
0.50
0.42
0.71
0.55
0.53
3.19 + function The function processing time is calculated by
processing time multiplying the number of functions times the
execution times given in the following table for each
function.
2.27
0.46
0.40
0.45
0.46
0.53
Appendix 3
Remarks
Function Ttime (ms)
ABS(x) 0.01
ACOS(x) 0.33
ASIN(x) 0.32
ATAN(x) 0.24
CO S(x) 0.17
SIN(x) 0.16
TAN(x) 0.21
EXP(x) 0.27
LN(x) 0.23
LO G(x) 0.25
P10(x) 0.52
SQRT (x) 0.04
233